277000775 Cable End for Sea-Doo Wake Pro HO 1503 2019

Cable End for Sea-Doo

This cable end is a replacement control cable fitting that connects and secures the cable assembly on your personal watercraft, referencing OEM part number 277000775.

Overview

This cable end serves as a direct-fit replacement for the original fitting on your watercraft, keeping the cable run tight and responsive so steering, throttle, or reverse controls move the way they should. It is built for riders who need to refresh a worn or missing cable end without hunting down a full assembly. The 277000775 cable end is a practical service part for routine maintenance and repair.

Built For Performance

• References OEM part number 277000775 for a confident match
• Constructed from corrosion-resistant materials suited to marine environments
• Threaded or pinned connection keeps the cable end seated under load
• Compact profile that installs in the existing cable bracket
• Designed to restore smooth cable travel on the water

Fits These Machines

• for Sea-Doo Wake Pro HO 1503
• for Sea-Doo 2019 Wake Pro models using this cable configuration

On-The-Job Use

• Refreshing a worn cable end during routine service
• Replacing a damaged fitting after a season on the water
• Restoring control response on the handlebars
• Keeping spares on hand for trailered or rental watercraft

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: It is an aftermarket cable end that references OEM number 277000775 for fitment. Confirm your model and cable assembly before ordering.

Q: Do I need to replace the whole cable? A: Not always, this end can be swapped when only the fitting is worn or damaged. Inspect the full cable for fraying or stiffness before installing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.