277000948 Reverse Cable for Sea-Doo GTX STD NA 1503 2007

Reverse Cable for Sea-Doo

This reverse cable for Sea-Doo is a direct replacement control cable that connects the reverse lever to the reverse gate on the jet pump, letting you engage forward, neutral, and reverse with a firm, consistent pull, and it is built to OEM reference 277000948.

Overview

This reverse cable for Sea-Doo restores reliable shifting on your personal watercraft by replacing a worn or seized cable that has become stiff or stops engaging altogether. The reverse cable for Sea-Doo is routed from the handlebar lever back to the reverse bucket, so smooth movement depends on a clean, properly sealed inner cable. It suits riders doing their own maintenance who want a fresh cable that bolts in without modifying the hull or steering assembly.

Built For Performance

• Constructed with a corrosion-resistant inner wire suited to constant moisture exposure
• Protective outer jacket shields the core from grit, salt, and sun degradation
• Factory-matched end fittings and cable length for the GTX STD NA platform
• Sealed cable housing helps keep water intrusion out of the core
• Engineered to match OEM reference 277000948 for a direct replacement fit
• Pre-lubricated core supports smooth lever travel from the first ride

Fits These Machines

• for Sea-Doo GTX STD NA 1503, 2007

On-The-Job Use

• Replacing a reverse cable that has seized or snapped mid-season
• Routine driveline maintenance on older GTX 1503 machines
• Restoring crisp reverse bucket movement before launching at the ramp
• Dock maneuverability where dependable reverse engagement matters

Specs At A Glance

Good To Know

Q: How do I know the reverse cable needs replacing? A: Common signs include a stiff or gritty lever, a reverse bucket that will not fully engage, and visible fraying or rust at the cable ends. If the lever travels without moving the bucket, the inner core has likely failed.

Q: Is the cable ready to install out of the box? A: It arrives as a complete cable assembly with the end fittings already attached, so no crimping or soldering is needed. Route it along the original path and adjust the gate linkage to spec once mounted.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.