277001729 Brass Cable Nut for Sea-Doo GTI STD HO 900 2017-2019

Brass Cable Nut for Sea-Doo

This brass cable nut, part number 277001729, secures control cables on personal watercraft so steering and throttle response stay consistent ride after ride.

Overview

This brass cable nut is a replacement fastening component made to hold cables firmly in place on personal watercraft. It serves riders and technicians who need reliable cable retention on a Sea-Doo GTI STD HO 900 without searching for discontinued hardware. The brass cable nut resists corrosion in wet marine environments where lesser fasteners break down.

Built For Performance

• Solid brass construction resists corrosion in saltwater and freshwater use
• Threaded body locks cable housings and fittings securely
• Direct replacement for OEM part number 277001729
• Compact profile fits tight cable routing points on personal watercraft
• Stable under vibration from engine and hull movement

Fits These Machines

• for Sea-Doo GTI STD HO 900 (2017-2019)

On-The-Job Use

• Replacing a seized, stripped, or corroded cable nut during seasonal maintenance
• Steering and throttle cable service on personal watercraft
• Shop and DIY repair work on Sea-Doo models
• Restoring cable tension after cable or housing replacement

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: This is an aftermarket brass cable nut that cross-references OEM part 277001729, not an original brand component. It is produced to match the fit and function of the factory part.

Q: Does this fit only the listed model years? A: This cable nut is listed for Sea-Doo GTI STD HO 900 models from 2017 through 2019. Confirm your machine's serial number and cable setup before ordering to be sure of compatibility.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.