277001729 Brass Cable Nut for Sea-Doo SP 155 1503 2012

Brass Cable Nut for Sea-Doo

This brass cable nut is a replacement fastener for the Sea-Doo SP 2 x 155 1503, cross-referenced to OEM part number 277001729, securing the steering or reverse cable to the hull fitting.

Overview

This brass cable nut is a direct-fit replacement for the Sea-Doo SP 2 x 155 1503, holding the control cable securely in its through-hull fitting. Matched to OEM part 277001729, the brass construction resists corrosion in wet marine environments where steel hardware fails. A practical hardware replacement for personal watercraft owners servicing steering or reverse cable connections.

Built For Performance

• Solid brass construction for strong corrosion resistance in wet environments
• Machined threads sized to match OEM 277001729 for a secure fit
• Hex profile allows tightening with a standard wrench
• Holds cables firmly to reduce vibration loosening over time
• Compact, low-weight hardware that installs in minutes

Fits These Machines

• for Sea-Doo SP 2 x 155 1503
• for Sea-Doo SP (2012)

On-The-Job Use

• Replacing stripped or corroded cable nuts during seasonal service
• Securing steering or reverse cable fittings on the Sea-Doo SP 2 x 155 1503
• Routine maintenance for craft run in salt or brackish water
• Dockside repairs where a factory-fit cable fastener is needed

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: No, this is an aftermarket brass cable nut made to fit the Sea-Doo SP 2 x 155 1503 and cross-referenced to OEM 277001729. It is not manufactured or branded by Sea-Doo.

Q: Why choose brass over a steel nut here? A: Brass resists corrosion better than plain steel in constant moisture, which matters for hardware sitting at a through-hull fitting. Confirm the part number matches your machine before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.