278001115 Start Stop Switch for Sea-Doo GTX 800 1997

Start/Stop Switch for Sea-Doo

This Start/Stop Switch for Sea-Doo is the handlebar control that starts and shuts off your personal watercraft, matched to OEM reference 278001115.

Overview

This Start/Stop Switch for Sea-Doo is a replacement handlebar control built for the GTX 800 and similar late 1990s models. The Start/Stop Switch for Sea-Doo lets you crank the starter and cut the engine from the helm. It fits riders servicing or restoring a 1997 Sea-Doo GTX 800.

Built For Performance

• Direct fit for the factory handlebar switch housing
• Momentary start contact and stop contact
• Sealed body resists spray and splash
• Weather-resistant wiring leads for marine use
• Simple two-wire hookup to the factory harness

Fits These Machines

• for Sea-Doo GTX 800 (1997)

On-The-Job Use

• Replacing a cracked or sticking handlebar switch
• Restoring starting and shutdown control on a 1997 GTX 800
• Routine maintenance of the helm controls on older Sea-Doo models

Specs At A Glance

Good To Know

Q: Will this switch plug into my existing wiring? A: It uses the same two-wire hookup as the factory switch on the GTX 800 and connects to the original harness.

Q: Does it control both starting and stopping? A: Yes, the switch has a momentary start contact and a stop contact, so it handles both functions from the handlebar.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.