278001969 Voltage Regulator for Sea-Doo 3D DI 951 2006-2007

Voltage Regulator for Sea-Doo

This voltage regulator for Sea-Doo replaces OEM 278001969 to keep your charging system output steady and your battery properly fed.

Overview

This direct-fit voltage regulator for Sea-Doo keeps charging voltage in check so your battery stays charged and your electronics stay protected. Built as a replacement for OEM 278001969, it fits the 3D DI 951 platform from 2006 to 2007. A solid choice for riders doing their own seasonal maintenance.

Built For Performance

• Direct replacement for OEM part number 278001969
• Regulates charging voltage to protect the battery and electrical components
• Solid-state construction with no moving parts to wear out
• Sealed housing resists water spray and engine bay conditions
• Plug-in style connector matches the factory wiring layout
• Built to handle the charging loads of the 951 DI platform

Fits These Machines

• for Sea-Doo 3D DI 951 (2006-2007)

On-The-Job Use

• Restores charging output when the original regulator fails
• Used during battery replacement and electrical troubleshooting
• Common maintenance swap on older 3D DI 951 units
• Helps prevent voltage spikes from damaging the MPEM and gauges

Specs At A Glance

Good To Know

Q: How do I know the regulator is the problem? A: A battery that keeps dying, dimming gauges, or voltage readings outside the normal charging range usually point to a failing regulator. Test charging output before replacing to confirm.

Q: Is this an original Sea-Doo part? A: No, this is an aftermarket replacement built to work with the listed Sea-Doo models and cross-references OEM 278001969. Always compare the part number and connector on your old unit before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.