278002283 Throttle Sensor Right for Sea-Doo Base 16-100 1630 2022

Throttle Sensor Right for Sea-Doo

The right-hand throttle sensor delivers grip position input to the engine control module on the Sea-Doo Base 16-100 1630, and it cross-references OEM 278002283.

Overview

This right throttle sensor for Sea-Doo is a direct-fit replacement for the original unit on the Base 16-100 1630. It converts twist-grip movement into an electronic signal so the ECU can meter throttle response accurately. Suited to owners and techs repairing sluggish, erratic, or dead throttle input on 2022 models.

Built For Performance

• Direct replacement for OEM part number 278002283
• Sealed housing resists splash and spray on the handlebar
• Contactless sensing element with no wiping wear surface
• Factory-style connector matches the original harness plug
• Calibrated signal output for smooth throttle response

Fits These Machines

• for Sea-Doo Base 16-100 1630, 2022

On-The-Job Use

• Replacing a throttle sensor that reads erratically or not at all
• Handlebar service on 1630-powered watercraft
• Restoring proper throttle response after control replacement
• Keeping on hand for rental or fleet maintenance

Specs At A Glance

Good To Know

Q: Can a bad throttle sensor put the craft in limp mode? A: Yes, the ECU often limits RPM when throttle input is unreliable, and a new sensor usually restores normal operation.

Q: Is this the left or right side unit? A: This is the right-hand throttle sensor, so confirm your handlebar setup and part number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.