278002283 Throttle Sensor Right for Sea-Doo GTI P SE 130 1503 2018

Throttle Sensor Right for Sea-Doo

This right-hand throttle sensor (OEM cross-reference 278002283) reads throttle grip position and sends that signal to the engine management system on select Sea-Doo GTI P SE 130 1503 personal watercraft.

Overview

This throttle sensor is a direct-fit replacement for the right side of the handlebar assembly on Sea-Doo GTI P SE 130 1503 models. It converts grip movement into an electronic signal the ECU uses to meter fuel and spark. Designed for riders replacing a failed or intermittent throttle sensor, it restores crisp, predictable throttle response.

Built For Performance

• Built to OEM cross-reference 278002283 for direct fitment
• Sealed housing resists water spray and humidity common on personal watercraft
• Electronic signal output matched to factory ECU calibration
• Right-side handlebar mounting position
• Constructed for repeated season-after-season use in marine conditions

Fits These Machines

• for Sea-Doo GTI P SE 130 1503

On-The-Job Use

• Replacing a worn or faulty throttle sensor on the right handlebar
• Restoring accurate throttle input after a sensor failure
• Routine maintenance on 2018 Sea-Doo GTI P SE 130 1503 watercraft

Specs At A Glance

Good To Know

Q: How do I know if my throttle sensor needs replacing? A: Common signs include delayed throttle response, erratic RPM changes, or a check engine warning on your Sea-Doo. A diagnostic scan can confirm a sensor fault before you order.

Q: Is this an original Sea-Doo part? A: This is an aftermarket throttle sensor built to cross-reference 278002283, not an original brand component. Confirm your model and serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.