278002283 Throttle Sensor Right for Sea-Doo GTI STD HO 900 2017-2019

Throttle Sensor Right for Sea-Doo GTI STD HO 900

This right-hand throttle sensor (OEM cross-reference 278002283) reads grip position and sends the signal that controls throttle response on Sea-Doo GTI STD HO 900 watercraft.

Overview

This throttle sensor right is a direct-fit replacement for the factory unit on Sea-Doo GTI STD HO 900 models. It relays twist-grip input to the engine management system so acceleration stays smooth and predictable on the water. Built for riders and mechanics who need a dependable throttle sensor without paying original-equipment pricing.

Built For Performance

• OEM cross-reference 278002283 for straightforward matching
• Right-side mounting position matches the factory layout
• Sealed housing resists splash, spray, and humidity
• Plug-in electrical connection for a clean install
• Constructed from corrosion-resistant materials for marine use
• Restores accurate throttle signal to the ECU

Fits These Machines

• for Sea-Doo GTI STD HO 900, 2017-2019

On-The-Job Use

• Replacing a failed or intermittent throttle sensor
• Routine maintenance on personal watercraft
• Restoring smooth acceleration response
• Shop and DIY repair work on Sea-Doo PWC

Specs At A Glance

Good To Know

Q: Will this sensor need programming after installation? A: In most cases the throttle sensor is a plug-and-play replacement, though some models may require a reset or calibration through a diagnostic tool.

Q: How do I know if my throttle sensor has failed? A: Common signs include erratic throttle response, limp mode warnings, or a check engine light, so scan for fault codes before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.