278002283 Throttle Sensor Right for Sea-Doo GTS P STDR 90 900 2018

Throttle Sensor Right for Sea-Doo

This right-side throttle sensor (OEM cross-reference 278002283) reads grip position and sends the signal that tells your engine how much power to deliver.

Overview

This throttle sensor is a direct-fit electronic component for your personal watercraft's right-hand throttle control. It converts your thumb or finger input at the grip into an electronic signal the engine management system uses to meter fuel and spark. Ideal for riders replacing a failed or intermittent throttle sensor on a Sea-Doo GTS P STDR 90 900.

Built For Performance

• OEM cross-reference 278002283 for accurate part matching
• Direct-fit replacement for the right-side throttle position sensor
• Sealed housing resists water spray and engine bay moisture
• Precision internal contacts for consistent signal output
• Plug-and-play connector matches the factory harness

Fits These Machines

• for Sea-Doo GTS STDR HO 900 (2017)
• for Sea-Doo GTS P STDR 90 900 (2018)

On-The-Job Use

• Restoring throttle response on a personal watercraft that surges or cuts out
• Replacing a worn sensor that throws fault codes or triggers limp mode
• Routine maintenance on a Sea-Doo GTS before the riding season

Specs At A Glance

Good To Know

Q: Will this throttle sensor fit both model years listed? A: It is designed to fit the 2017 Sea-Doo GTS STDR HO 900 and the 2018 Sea-Doo GTS P STDR 90 900, both of which reference the same OEM number. Confirm your machine's serial number before ordering.

Q: Is this an original Sea-Doo part? A: This is an aftermarket throttle sensor made to fit Sea-Doo models that use OEM number 278002283; it is not an original Sea-Doo product. Always verify your part number on the machine before purchase.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.