278002283 Throttle Sensor Right for Sea-Doo GTX LTD IS 260 1503 2010-2017

Throttle Sensor Right for Sea-Doo

This right-hand throttle sensor is a direct-fit electronic component for Sea-Doo personal watercraft, cross-referenced to OEM part number 278002283.

Overview

This throttle sensor is a replacement electronic component for the right side of the handlebar on select Sea-Doo personal watercraft. It reads throttle position and sends that signal to the engine management system so fuel delivery and power output respond accurately to rider input. It is intended for riders and mechanics servicing or restoring a compatible machine.

Built For Performance

• Direct cross-reference to OEM part number 278002283
• Right-side throttle position sensing for accurate signal output
• Plug-in electrical connection matched to the original harness
• Sealed housing built to resist water and spray exposure
• Restores accurate throttle response after sensor failure

Fits These Machines

• for Sea-Doo GTX LTD IS 260 1503, 2010-2017

On-The-Job Use

• Routine replacement when throttle response becomes erratic
• Diagnostic repair after a sensor fault code appears
• Restoration of a stored or aging personal watercraft
• Handlebar assembly service and rebuilds

Specs At A Glance

Good To Know

Q: Will this sensor plug directly into my machine's factory wiring? A: It is built to match the original connector and mounting point for the listed model, so installation uses the factory harness without adapters.

Q: How do I know the throttle sensor is the fault? A: A stored fault code for throttle position or a sudden hesitation and limp mode on the water are the usual signs. Confirm the diagnosis before replacing the part.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.