278002283 Throttle Sensor Right for Sea-Doo RXP P XRS 300 1630 2018

Throttle Sensor Right for Sea-Doo

This right-side throttle sensor is a direct-fit electronic replacement that reads throttle position and relays it to your watercraft's engine management system, cross-referencing OEM part 278002283.

Overview

This throttle sensor right is built for Sea-Doo RXP, RXP P, and RXP XRS 300 models running the 1630 engine and provides accurate throttle position data to the ECU. The throttle sensor right restores precise throttle response when the original component wears out or fails. It is aimed at owners of 2018 model year watercraft handling their own replacement.

Built For Performance

• Direct cross-reference to OEM part 278002283 for a clean swap
• Sealed body guards against moisture and salt spray common on personal watercraft
• Precision internal contact tracks throttle movement for consistent signal output
• Factory-style connector plugs into the existing harness on supported models
• Right-side mounting design matches the original bracket position

Fits These Machines

• for Sea-Doo RXP 300 with 1630 engine, 2018
• for Sea-Doo RXP P 300 with 1630 engine, 2018
• for Sea-Doo RXP XRS 300 with 1630 engine, 2018

On-The-Job Use

• Replacing a faulty sensor that triggers limp mode or unstable idle
• Restoring linear throttle response during acceleration and cruising
• Routine service on 1630-powered Sea-Doo watercraft
• Repair when diagnostic codes point to throttle signal faults

Specs At A Glance

Good To Know

Q: Does this sensor fit all 1630-powered RXP variants? A: It is intended for RXP, RXP P, and RXP XRS 300 models from 2018, so verify your exact model and year first. Q: Will fault codes need to be cleared after install? A: The ECU usually recognizes the new sensor on its own, though a dealer scan tool can clear stored codes if any remain.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.