278002283 Throttle Sensor Right for Sea-Doo RXP X 325 1630 2024-2026

Throttle Sensor Right for Sea-Doo RXP X 325 1630

This right-side throttle sensor is a direct replacement electronic component for the Sea-Doo RXP X 325 1630, cross-referencing OEM part number 278002283, and it restores accurate throttle position signals to the engine management system.

Overview

This Throttle Sensor Right is built for the Sea-Doo RXP X 325 1630 and delivers precise throttle position data to the ECU so the engine responds cleanly through the full power band. The 278002283 cross-reference makes it a straightforward replacement for a worn or failed sensor on 2024 to 2026 models. It suits riders who want reliable throttle input without chasing down discontinued OEM stock.

Built For Performance

• Direct cross-reference to OEM part number 278002283 for confident fitment
• Right-side mounting position matches factory sensor location
• Sealed connector body resists water intrusion in engine bay conditions
• Consistent signal output supports smooth throttle response
• Constructed for the vibration and heat of marine engine use

Fits These Machines

• for Sea-Doo RXP X 325 1630, 2025
• for Sea-Doo RXP X 325 1630, 2024
• for Sea-Doo RXP X 325 1630, 2026

On-The-Job Use

• Replacing a failed throttle position sensor on the right side of the handlebar assembly
• Restoring throttle signal accuracy after fault codes appear
• Routine maintenance on 2024 to 2026 RXP X 325 watercraft
• Repairing intermittent throttle response issues traced to sensor failure

Specs At A Glance

Good To Know

Q: Will this throttle sensor plug directly into my factory harness? A: It is designed as a direct replacement for OEM part 278002283 with the right-side connector layout for the RXP X 325 1630. Always match the part number against your existing sensor before installation.

Q: Do I need to recalibrate anything after installing it? A: In most cases the ECU reads the new sensor automatically once it is connected. If a fault code persists, clearing it with a diagnostic tool is recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.