278002283 Throttle Sensor Right for Sea-Doo RXT STD 260 1503 2017

Throttle Sensor Right for Sea-Doo

This right-side throttle sensor for Sea-Doo replaces OEM part 278002283 and communicates grip position to the engine management system so throttle response stays sharp and predictable.

Overview

This throttle sensor for Sea-Doo is a direct-fit electronic component that reads right-hand throttle position and relays that signal to the ECU. It restores accurate fuel and ignition control on 2017 RXT STD 260 1503 models. Built for riders and mechanics who need a dependable replacement without guesswork.

Built For Performance

• Direct replacement for OEM part number 278002283
• Right-side mounting position for correct handlebar fitment
• Sealed connector housing resists water intrusion in marine conditions
• Plug-and-play wiring connection with no splicing required
• Constructed from corrosion-resistant materials for prolonged water exposure
• Maintains accurate throttle position signal to the engine management system

Fits These Machines

• for Sea-Doo RXT STD 260 1503 2017

On-The-Job Use

• Replacing a failed or intermittent throttle sensor on the watercraft
• Restoring proper throttle response after a sensor fault code
• Routine maintenance on 2017 RXT STD 260 1503 models
• Shop repairs where OEM part 278002283 is specified

Specs At A Glance

Good To Know

Q: Will this sensor work on other Sea-Doo models? A: This unit is listed for the 2017 RXT STD 260 1503 with OEM part 278002283. Confirm your model and part number before ordering to ensure correct fitment.

Q: Does the sensor need programming after installation? A: It connects through the factory harness and typically requires no special calibration. If a fault code persists, a dealer scan tool may be needed to clear it.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.