278002283 Throttle Sensor Right for Sea-Doo Spark 2Up 900 2015-2026

Throttle Sensor Right for Sea-Doo

This right-side throttle sensor replaces OEM part 278002283 to restore accurate throttle response on your watercraft.

Overview

The Throttle Sensor Right for Sea-Doo is a direct-fit electronic component that translates grip position into a signal your engine management system can read. This throttle sensor keeps acceleration smooth and predictable on the water. It suits riders maintaining or repairing a Spark 2Up 900.

Built For Performance

• Direct replacement for OEM part number 278002283
• Right-side mounting position for correct cable and wiring routing
• Sealed housing resists moisture and spray exposure
• Plug-in electrical connector for straightforward installation
• Built to maintain consistent signal output across the throttle range

Fits These Machines

• for Sea-Doo Spark 2Up 900, 2015-2026

On-The-Job Use

• Restoring throttle response on a Spark that hesitates or cuts out
• Scheduled maintenance on high-hour personal watercraft
• Repairing a craft after water intrusion in the handlebar controls
• Replacing a failed sensor before a weekend ride

Specs At A Glance

Good To Know

Q: Will this sensor fit my Spark? A: It is listed for the Spark 2Up 900 from 2015 to 2026, so verify your model and model year before ordering. Q: Do I need to reset anything after installing it? A: Most craft relearn throttle position automatically once the sensor is connected, but check your service manual for any calibration step.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.