278002283 Throttle Sensor Right for Sea-Doo Spark 60 2Up 900 2021-2026

Throttle Sensor Right for Sea-Doo Spark

This right-hand throttle sensor is a direct-fit replacement for the Sea-Doo Spark platform, cross-referencing OEM part number 278002283 to restore accurate throttle response.

Overview

This right throttle sensor for Sea-Doo Spark is the component that translates grip position into the electronic signal your engine management system reads. It is built for riders and mechanics replacing a failed or intermittent sensor on the 60 2Up 900 platform. Installing this throttle sensor for Sea-Doo Spark restores consistent accelerator input from idle through full throttle.

Built For Performance

• Direct cross-reference to OEM part number 278002283
• Right-hand side fitment for the 60 2Up 900 configuration
• Sealed connector body built to resist water intrusion
• Plug-in installation with no splicing required
• Constructed for marine-grade corrosion resistance
• Maintains the electronic throttle signal demanded by the engine control module

Fits These Machines

• for Sea-Doo Spark 60 2Up 900, model years 2021 through 2026

On-The-Job Use

• Replacing a throttle sensor that throws codes or cuts power
• Restoring smooth acceleration after water intrusion damage
• Routine servicing of the handlebar control group
• Diagnostic repair after intermittent limp mode events

Specs At A Glance

Good To Know

Q: Will this sensor need calibration after installation? A: Most applications read the new sensor automatically on startup, but a dealer diagnostic tool can confirm correct voltage range if a fault code persists. Q: Can a bad throttle sensor cause limp mode? A: Yes, an erratic or open signal is a common trigger for reduced power mode on this platform, so replacing the sensor often clears the condition.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.