278002283 Throttle Sensor Right for Sea-Doo Spark NA 900 2014

Throttle Sensor Right for Sea-Doo

This right-side throttle sensor (part number 278002283) is a replacement component that reads throttle input and sends the signal your engine management system needs to deliver smooth, responsive power.

Overview

This throttle sensor for Sea-Doo is a direct-fit replacement for the right-hand throttle position sensing unit on the 2014 Spark NA 900. It restores accurate throttle signal delivery so the engine responds cleanly across the rev range. This throttle sensor suits riders replacing a failed or erratic unit on their personal watercraft.

Built For Performance

• Constructed to match the OEM fitment of part number 278002283
• Handles the heat and moisture typical of marine engine compartments
• Sealed connector design resists water intrusion
• Delivers consistent throttle position feedback to the ECU
• Right-side configuration specific to the Spark platform

Fits These Machines

• for Sea-Doo Spark NA 900, 2014

On-The-Job Use

• Replacing a worn throttle sensor on a 2014 Spark NA 900
• Restoring throttle response after sensor failure
• Routine maintenance on Sea-Doo personal watercraft
• Keeping throttle input accurate for confident riding

Specs At A Glance

Good To Know

Q: How do I know if my throttle sensor has failed? A: Common signs include erratic throttle response, hesitation, or a check engine alert on your Spark. Diagnosing the sensor before replacement helps confirm the fault.

Q: Does this sensor require any calibration after installation? A: Most throttle sensors of this type are plug-and-play on the 2014 Spark NA 900, though verifying fitment against your serial number is always wise. Follow your service manual for any reset procedure.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.