278002283 Throttle Sensor Right for Sea-Doo Spark TRIXX 3Up 900 2017-2026

Throttle Sensor Right for Sea-Doo

This right-hand throttle sensor, part number 278002283, is a replacement electronic component that reads throttle position and transmits that signal to the engine management system on the watercraft.

Overview

This throttle sensor right for Sea-Doo is built for the Spark TRIXX 3Up 900 platform. It delivers throttle position data to the engine control module so fueling and ignition stay in sync with rider input. A practical replacement for owners and technicians servicing these machines.

Built For Performance

• Right-side throttle position sensing for accurate signal output
• Replacement part number 278002283 for easy sourcing
• Sealed connector design to resist moisture and spray
• Direct-fit mounting for the Spark TRIXX 3Up 900 configuration
• Built for consistent electrical contact across the throttle range
• Suited to the 2017-2026 model year range

Fits These Machines

• for Sea-Doo Spark TRIXX 3Up 900, 2017-2026

On-The-Job Use

• Replacing a failed or erratic throttle sensor on the water
• Routine electrical maintenance during off-season servicing
• Restoring smooth throttle response for recreational riding

Specs At A Glance

Good To Know

Q: Will this sensor need calibration after installation? A: Some throttle sensor replacements require a reset or relearn through the engine management system. Confirm the procedure for the specific model before riding.

Q: Is this an original Sea-Doo part? A: This is a replacement throttle sensor offered for Sea-Doo machines and is not presented as an original factory part. Verify the part number against the existing component.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.