278002283 Throttle Sensor Right for Sea-Doo Wake Pro HO 1503 2019

Throttle Sensor Right for Sea-Doo

This right-side throttle sensor is a direct-fit electronic replacement cross-referencing OEM part number 278002283, delivering throttle position signals to the engine management system on Sea-Doo personal watercraft.

Overview

This throttle sensor for Sea-Doo is a right-hand electronic unit that monitors throttle lever position and transmits the reading to the engine control module. The throttle sensor for Sea-Doo restores consistent throttle response when the original sensor fails or reads erratically. It fits the Sea-Doo Wake Pro HO 1503 from 2019 and similar 1503-powered models.

Built For Performance

• Cross-references OEM part number 278002283
• Right-side position matching factory fitment
• Sealed connector to resist moisture in marine environments
• Electronic output compatible with the 1503 engine management system
• Housing designed to handle vibration and water exposure
• Plug-in installation with the factory wiring harness

Fits These Machines

• for Sea-Doo Wake Pro HO 1503 (2019)
• for Sea-Doo Wake STD 155 1503 (2017)

On-The-Job Use

• Replacing a faulty or intermittent right throttle sensor
• Restoring smooth throttle response on the water
• Electrical diagnostics and repair on Sea-Doo PWC
• Shop or DIY maintenance on 1503-powered models

Specs At A Glance

Good To Know

Q: Does this throttle sensor need calibration after installation? A: Many Sea-Doo models require a throttle position reset or relearn through a diagnostic tool after fitting a new sensor. Check your service manual for the correct procedure.

Q: Is this an original Sea-Doo part? A: This is an aftermarket throttle sensor built to cross-reference OEM part 278002283. It is not an original Sea-Doo product.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.