278002284 Throttle Sensor Left for Sea-Doo GTI P SE 130 1503 2018

Throttle Sensor Left for Sea-Doo

This left throttle sensor, part number 278002284, is a direct-fit replacement component that reads throttle position and sends that signal to the engine management system on 2018 Sea-Doo GTI P SE 130 models with the 1503 engine.

Overview

This throttle sensor for Sea-Doo delivers the position feedback the ECM needs to meter fuel and manage ignition timing. Built as a drop-in replacement for the left-hand throttle assembly, this throttle sensor keeps acceleration response crisp on 2018 GTI P SE 130 machines running the 1503 powerplant. It suits riders replacing a failed or intermittent sensor on a personal watercraft that has to start and run reliably every time it hits the water.

Built For Performance

• Direct replacement for OEM part number 278002284
• Constructed for marine use with sealed electrical connections
• Delivers consistent throttle position signal to the engine management system
• Fits the left-side throttle assembly on 1503-equipped models
• Plug-in connector matches the factory harness

Fits These Machines

• for Sea-Doo GTI P SE 130, 2018, 1503 engine

On-The-Job Use

• Replacing a failed throttle sensor on a 2018 GTI P SE 130
• Restoring throttle response after intermittent signal faults
• Routine maintenance on 1503-powered Sea-Doo watercraft

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: This is an aftermarket throttle sensor for Sea-Doo that cross-references OEM part number 278002284. Confirm your model and serial number before ordering.

Q: Will this fit either throttle side? A: This unit is the left throttle sensor and is not interchangeable with the right-side sensor. Match the part number to your application.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.