278002284 Throttle Sensor Left for Sea-Doo GTI P STD 90 900 2018

Throttle Sensor Left for Sea-Doo

This left throttle sensor is a direct-fit electronic replacement that reads lever position and relays it to the engine management system, cross-referenced to OEM part number 278002284.

Overview

The left throttle sensor for Sea-Doo restores accurate throttle input on your personal watercraft. This throttle sensor for Sea-Doo replaces a failed or intermittent unit so the ECU gets a clean position signal again. It fits GTI P STD 90 900 models and suits riders and techs who want a dependable throttle sensor for Sea-Doo.

Built For Performance

• Cross-referenced to OEM part number 278002284 for easy matching
• Left-side fitment matching the factory mounting point
• Sealed construction built to handle moisture and spray
• Direct plug-in connector for straightforward replacement
• Stable signal output for consistent throttle response
• Slim body that clears nearby handlebar hardware

Fits These Machines

• for Sea-Doo GTI P STD 90 900 (2018)

On-The-Job Use

• Fixing rough running or hesitation caused by a bad throttle signal
• Replacing a sensor during handlebar or steering work
• Servicing a GTI P STD 90 900 after corrosion or water exposure

Specs At A Glance

Good To Know

Q: Does this sensor require calibration after fitting? A: Most throttle sensors of this type install without dealer programming, but some models call for a throttle relearn. Check the procedure for your specific model year first.

Q: What symptoms point to a failing throttle sensor? A: Erratic idle, delayed response, or throttle-related fault codes are typical signs. Verifying sensor output against specification confirms the fault before you replace it.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.