278002284 Throttle Sensor Left for Sea-Doo GTI SE 130 1630 2020-2026

Throttle Sensor Left for Sea-Doo

The Throttle Sensor Left is a direct-fit replacement electronic component for Sea-Doo personal watercraft, cross-referencing OEM part number 278002284, that relays throttle position data to the engine management system for accurate power delivery.

Overview

This Throttle Sensor Left for Sea-Doo is a replacement electronic component that reads throttle lever position and sends that signal to the watercraft's engine control module. The throttle sensor for Sea-Doo helps maintain smooth acceleration and consistent power response across the RPM range. It is intended for riders and technicians replacing a failed or worn throttle sensor on compatible Sea-Doo models.

Built For Performance

• Cross-references OEM part number 278002284 for direct replacement
• Left-side mounting position matches the original fitment location
• Sealed connector housing resists moisture in marine environments
• Solid-state sensing element delivers consistent signal output
• Constructed for vibration and temperature exposure on the water
• Plug-in wiring connection simplifies installation

Fits These Machines

• for Sea-Doo GTI SE 130 1630, 2020-2026

On-The-Job Use

• Replacing a failed throttle sensor that causes erratic engine response
• Restoring accurate throttle input after electrical fault diagnosis
• Routine maintenance on high-hour Sea-Doo personal watercraft
• Shop repairs where OEM part 278002284 is specified

Specs At A Glance

Good To Know

Q: How do I know the throttle sensor needs replacing? A: Common signs include hesitation, erratic idle, or a check engine warning on the gauge cluster. Confirming the fault with a diagnostic scan before ordering is recommended.

Q: Does this sensor require programming after installation? A: In most cases the throttle sensor is a plug-in replacement that the engine management system recognizes automatically. A dealer scan tool may be needed to clear stored fault codes after the swap.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.