278002284 Throttle Sensor Left for Sea-Doo GTR P X 230 1503 2018

Throttle Sensor Left for Sea-Doo

This left throttle sensor is a replacement electronic component that translates thumb lever movement into a signal the engine management system reads to control throttle response on select Sea-Doo watercraft.

Overview

The Throttle Sensor Left is a direct-fit electrical part for keeping throttle input accurate on your personal watercraft. This left throttle sensor restores the signal path between the handlebar lever and the engine control module so acceleration stays smooth and predictable. It suits riders performing routine electrical service or replacing a failed throttle sensor on a compatible Sea-Doo model.

Built For Performance

• Direct-fit replacement for the left side throttle position sensor
• Sealed connector designed for marine electrical environments
• Restores accurate throttle signal to the engine control module
• Compact housing sized to original mounting points
• Built to withstand vibration and repeated lever actuation

Fits These Machines

• for Sea-Doo GTR P X 230 1503 (2018)
• for Sea-Doo GTR P STD 230 1503 (2018)

On-The-Job Use

• Throttle lever repair on 2018 Sea-Doo GTR 230 watercraft
• Diagnostic replacement after fault codes point to throttle sensor signal
• Routine electrical maintenance on the handlebar control cluster
• Restoring smooth acceleration response on the water

Specs At A Glance

Good To Know

Q: Does this sensor require programming after installation? A: Most installations are plug-and-play, though a dealer scan tool may be needed to clear codes or verify calibration on some models. Confirm your watercraft's wiring and connector match before ordering.

Q: Is this sold as a pair for both sides? A: This listing covers the left throttle sensor only. Check your existing part number to confirm which side you need to replace.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.