278002284 Throttle Sensor Left for Sea-Doo GTX STD 300 1630 2021-2026

Throttle Sensor Left for Sea-Doo

This left-hand throttle sensor (part number 278002284) is an electronic accelerator position component that relays grip position to the engine management system on personal watercraft.

Overview

This throttle sensor left is a direct-fit replacement for the original accelerator position pickup on select Sea-Doo models. The throttle sensor left restores accurate throttle-by-wire signaling so the engine responds cleanly through the full grip range. It suits riders replacing a failed or erratic throttle sensor left on a 2021 to 2026 GTX STD 300 1630.

Built For Performance

• Cross-reference part number 278002284 for straightforward replacement
• Left-side mounting matches the factory sensor position
• Sealed housing resists splash and bilge moisture
• Plug-in connector for OEM-style wiring
• Contactless position sensing for smooth signal output
• Compact body fits the stock handlebar assembly

Fits These Machines

• for Sea-Doo GTX STD 300 1630 (2021)
• for Sea-Doo GTX STD 300 1630 (2022)
• for Sea-Doo GTX STD 300 1630 (2023)
• for Sea-Doo GTX STD 300 1630 (2024)
• for Sea-Doo GTX STD 300 1630 (2025)
• for Sea-Doo GTX STD 300 1630 (2026)

On-The-Job Use

• Restoring throttle response after a sensor failure
• Routine replacement during handlebar service
• Diagnosing throttle-by-wire fault codes
• Refreshing controls before a riding season

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: No, it is an aftermarket replacement built to work in place of the factory throttle sensor, and it is not manufactured by Sea-Doo.

Q: Will it need calibration after installation? A: Most throttle-by-wire systems learn the sensor range through a reset procedure, so plan on verifying grip travel or running a scan tool check after fitting.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.