2815CS Ring Set 71.50mm for Wiseco

Ring Set for Wiseco

This 71.50mm ring set for Wiseco is a piston ring kit that seals the combustion chamber and manages oil control in a two-stroke or four-stroke engine build.

Overview

This 71.50mm piston ring set for Wiseco delivers a precise seal between piston and cylinder wall for rebuilds and top-end refreshes. It suits engine builders and riders who want a dependable ring set for Wiseco pistons sized at 71.50mm. Each ring set for Wiseco is manufactured to match the piston groove dimensions for consistent compression and oil control.

Built For Performance

• 71.50mm bore sizing for a precise fit in the matching cylinder
• Ring set configuration intended for a single piston assembly
• Constructed from quality ring materials for heat and wear resistance
• Designed to restore compression in a top-end rebuild
• Sold as a complete set for one piston

Specs At A Glance

Good To Know

Q: Is this ring set sold for one piston or a full engine? A: This is a single-piston ring set sized at 71.50mm. Confirm the quantity needed for your build before ordering.

Q: Does the ring set come with installation instructions? A: Piston ring sets are typically installed per the piston maker's end gap and orientation specs. Refer to your service manual for correct gap and placement.

On-The-Job Use

• Top-end rebuilds on 71.50mm bore engines
• Compression restoration during piston replacement
• Routine ring replacement in performance builds

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.