2905KD Ring Set 73.80mm for Wiseco

Ring Set for Wiseco

This 73.80mm ring set replaces worn piston rings, restoring compression and oil control in engines that run for Wiseco pistons of matching bore size.

Overview

This 73.80mm ring set is built to replace the rings on a matching Wiseco piston of the same bore, delivering proper wall tension and sealing. The ring set brings back compression and oil control when rings wear past spec or a rebuild calls for fresh hardware. It suits engine builders and riders doing a top-end refresh that runs for Wiseco pistons.

Built For Performance

• 73.80mm bore size matches its specified piston application
• Ring set configured for a single piston application
• Sold as a complete ring set for one piston
• Intended for rebuild and top-end refresh work

Specs At A Glance

Good To Know

Q: Will this ring set fit any 73.80mm piston? A: No, ring sets are sized to the specific piston groove design they were made for, so verify the matching piston number first.

Q: Is this sold for one piston or a full set? A: Ring sets like this are typically sold for a single piston, so confirm the quantity your build needs.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.