2913CD Ring Set 74.00mm for Wiseco

Ring Set for Wiseco

This 74.00mm ring set replaces worn or damaged piston rings, restoring compression and oil control in high-performance engines that run for Wiseco pistons.

Overview

This 74.00mm ring set is a direct replacement for the rings supplied with Wiseco 74.00mm pistons, sized to keep proper tension against the cylinder wall. The ring set restores sealing, compression, and oil control when rings wear or a rebuild calls for fresh hardware. It suits engine builders and riders refreshing a top end that runs for Wiseco pistons.

Built For Performance

• 74.00mm bore size matches the piston it was spec'd for
• Ring set configured for a single piston application
• Sold as a complete ring set for one piston
• Intended for rebuild and top-end refresh work

Specs At A Glance

Good To Know

Q: Does this ring set fit any 74.00mm piston? A: No, ring sets are cut for the specific piston groove design they were made for, so confirm the matching piston number before ordering.

Q: Is this sold as a set for one piston or multiple pistons? A: Ring sets of this type are typically sold for one piston, so check the quantity you need for your build.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.