Skip to product information
1 of 1

2913CS Wiseco Piston Ring Set 74.00 mm Ring Set

2913CS Wiseco Piston Ring Set 74.00 mm Ring Set

Regular price $50.59
Regular price Sale price $50.59
Sale Sold out
Quantity

Piston Ring Set - 74.00 mm for Wiseco 2913CS

This 2913CS piston ring set for Wiseco is a 74.00 mm ring set that seals the piston-to-cylinder gap for proper compression and oil control.

Overview

This 74.00 mm piston ring set for Wiseco is built to seal the combustion chamber on a rebuild or top-end refresh. The ring set controls compression, oil, and blow-by as the piston travels the cylinder bore. It suits riders and mechanics rebuilding an engine that runs the 2913CS piston.

Built For Performance

  • 74.00 mm bore size for an exact fit to the matching piston
  • Ring set includes the rings needed for one piston
  • Hard-wearing ring faces for reliable sealing under heat and load
  • Precise end gaps for consistent compression
  • Sold as a set for a single-cylinder top-end rebuild

On-The-Job Use

  • Top-end rebuilds and piston replacements
  • Refresh after a seize or low-compression diagnosis
  • Routine ring replacement during a rebuild
  • Shop and garage engine work

Specs At A Glance

Part Number(s) 2913CS
Bore Size 74.00 mm
Type Piston Ring Set
Brand Reference for Wiseco

Good To Know

Q: How do I check ring end gap before assembly? A: Square the ring in the bore with a piston and measure the gap with a feeler gauge against the spec for your engine. Q: Should I file-fit these rings? A: Only file the ends if the measured gap falls below the minimum, and go slowly to avoid removing too much material.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details