2913XC Ring Set 74.00mm for Wiseco

Ring Set, 74.00mm for Wiseco

This 74.00mm ring set is a piston ring replacement built to seal the combustion chamber, manage oil control, and restore compression in compatible engines.

Overview

This 74.00mm ring set supplies the sealing rings required during a top end rebuild, helping bring back compression and oil control in compatible engines. The ring set suits riders, mechanics, and engine builders handling piston or cylinder work. Each ring is sized at 74.00mm to match the corresponding piston bore.

Built For Performance

• 74.00mm bore sizing for a precise match to the piston
• Ring set layout designed for compression and oil control
• Made to handle the demands of small engine and powersports use
• Sized to the listed bore for consistent cylinder wall sealing
• Suited to top end rebuilds and piston replacement work

On-The-Job Use

• Top end rebuilds on small engines
• Piston and cylinder refresh work
• Powersports engine repair
• Routine maintenance requiring ring replacement

Specs At A Glance

Good To Know

Q: How can I confirm this ring set matches my engine? A: Check that your piston bore is 74.00mm and that the part number 2913XC applies to your setup. Bore size must match the piston for proper sealing.

Q: Do rings need measuring before assembly? A: Ring end gap should be checked during assembly and compared against the engine manufacturer's specification. Correct gap supports reliable sealing and compression.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.