292000974 Thru Hull Fitting for Sea-Doo Wake Pro 215 1503 2009

Thru Hull Fitting for Sea-Doo

This thru hull fitting is a replacement hull drain and fitting component made to seal and route water lines through the hull of your personal watercraft, cross-referenced under OEM part number 292000974.

Overview

This thru hull fitting serves as a direct replacement for the hull drain and water passage point on select Sea-Doo personal watercraft. The thru hull fitting seals the hull opening while allowing water lines and drain paths to pass cleanly through, keeping the bilge area dry and the cooling system routed correctly. It suits riders replacing a cracked, corroded, or leaking fitting on a machine that sees regular water time.

Built For Performance

• Cross-referenced to OEM part number 292000974 for straightforward lookup
• Seals the hull opening to limit water intrusion into the bilge
• Fits the 1503 engine platform hulls listed for this part
• Rugged construction suited to constant marine exposure
• Direct replacement design, no fabrication required
• Retains factory water routing through the hull

Fits These Machines

• for Sea-Doo Wake Pro 215, 2009
• for Sea-Doo SP 1 x 260, 2012

On-The-Job Use

• Restoring hull sealing after a cracked or degraded fitting
• Bilge drain and water passage maintenance
• Pre-season inspection and replacement before launch
• Repair work on 1503-equipped Sea-Doo hulls

Specs At A Glance

Good To Know

Q: Does this fit my model year? A: Confirm the hull and serial number on your machine, since thru hull fittings can vary between production runs on the same model.

Q: Can I reuse the old hardware? A: Reusing seals and fasteners is not advised on a fitting exposed to water, so a fresh sealant and hardware set protects against leaks.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.