292000975 Thru the Hull Fitting for Sea-Doo SP 2 x 260 1503 2012

Thru the Hull Fitting for Sea-Doo

This thru the hull fitting provides a sealed pass-through point where cooling or bilge lines cross the hull, and it is a direct fit for Sea-Doo applications referencing OEM 292000975.

Overview

This thru the hull fitting is the hull-mounted component that lets water or cooling lines pass cleanly through the hull shell while keeping the bilge side sealed. It is made for Sea-Doo personal watercraft service and replacement, giving riders and mechanics a dependable thru the hull fitting that restores the original connection point. It suits anyone servicing a 2012 Sea-Doo SP 2 x 260 1503 or a similar hull layout that calls for this fitting.

Built For Performance

• Hull-mounted pass-through that seals against water intrusion at the hull shell
• Direct fit for the 292000975 fitting position
• Houses cooling or drain line routing at the hull wall
• Retains the factory connection point for straightforward replacement
• Rugged construction for the marine environment

Fits These Machines

• for Sea-Doo SP 2 x 260 1503
• for Sea-Doo SP 2 x 215 1503
• for Sea-Doo applications using fitting 292000975

On-The-Job Use

• Replacing a cracked or leaking hull fitting
• Routine cooling system service
• Hull repair after impact damage
• Refit work during engine or pump service

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: No, it is an aftermarket thru the hull fitting that cross-references OEM number 292000975. Always confirm your hull fitting number before ordering.

Q: What can cause a thru the hull fitting to need replacement? A: Age, UV exposure, impact damage, or a dried gasket can cause leaks or cracks at the hull wall. Inspect the fitting and its seal surfaces before refitting.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.