293200087 Jet Pump Trim Seal for Sea-Doo GTI P STD 90 900 2018

Jet Pump Trim Seal for Sea-Doo

This jet pump trim seal, cross-referenced under OEM part number 293200087, seals the trim nozzle assembly on personal watercraft to keep water flow controlled and reduce unwanted leakage around the pump exit.

Overview

This jet pump trim seal is a direct-fit sealing component for the trim nozzle on select personal watercraft. It helps maintain a clean seal at the pump trim assembly so the jet stream stays consistent during acceleration and steering. Built for riders who service their own PWC, this trim seal is a practical replacement for a worn or flattened original.

Built For Performance

• OEM cross-reference 293200087 for accurate fitment matching
• Seals the trim nozzle assembly to reduce water leakage
• Supports consistent jet stream direction during steering input
• Resistant to repeated water and spray exposure
• Flexible construction that seats well against mating surfaces

Fits These Machines

• for Sea-Doo GTI P STD 90 900, 2018
• for Sea-Doo GTI P SE 90 900, 2018

On-The-Job Use

• Replacing a compressed or damaged trim seal during pump service
• Routine maintenance on the jet pump nozzle assembly
• Restoring proper trim response on the water
• Seasonal teardown and rebuild of the pump section

Specs At A Glance

Good To Know

Q: How do I know if this trim seal needs replacing? A: A compressed, cracked, or deformed seal can allow water past the trim nozzle and affect jet stream consistency. Inspect it whenever the pump assembly is apart.

Q: Is this an original Sea-Doo part? A: This is an aftermarket replacement item built for Sea-Doo models and is not an original brand product. Confirm your model and serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.