293350020 Thrust Washer for Sea-Doo LRV 951 2000-2001

Thrust Washer for Sea-Doo

This thrust washer, OEM cross-reference 293350020, is a driveline spacing component that sits against the impeller shaft to control axial play and protect the pump assembly from excess movement.

Overview

This thrust washer is a direct-fit replacement component for the jet pump assembly on personal watercraft, built to take up axial clearance on the impeller shaft. The 293350020 thrust washer helps keep the shaft properly seated so the driveline stays stable under load. It suits riders performing routine pump maintenance or rebuilding a worn jet drive.

Built For Performance

• OEM cross-reference 293350020 for reliable fitment matching
• Precision-formed to control axial shaft play in the jet pump
• Durable metal construction suited to constant marine service
• Reduces metal-to-metal contact between shaft and housing surfaces
• Simple drop-in replacement during pump or impeller service
• Corrosion-resistant finish for freshwater and saltwater use

Fits These Machines

• for Sea-Doo LRV 951, 2000-2001

On-The-Job Use

• Jet pump rebuilds and impeller replacement jobs
• Routine driveline inspection and service intervals
• Restoring proper shaft end play after wear is found
• Seasonal maintenance on personal watercraft

Specs At A Glance

Good To Know

Q: Where does this thrust washer install? A: It fits onto the impeller shaft within the jet pump assembly to control axial clearance. Consult your service manual for the exact position during reassembly.

Q: Should I replace it during a pump rebuild? A: Thrust washers wear over time, so replacing this 293350020 washer while the pump is apart is a practical step. Always verify clearances after installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.