293350020 Thrust Washer for Sea-Doo SPX 800 1997-1999 Jet Ski Part

Thrust Washer for Sea-Doo SPX 800

This thrust washer (OEM cross-reference 293350020) is a replacement driveline component designed to control axial play in the jet pump assembly for Sea-Doo SPX 800 watercraft.

Overview

This thrust washer serves as a direct replacement for the OEM 293350020 part used on Sea-Doo SPX 800 personal watercraft. The thrust washer sits in the jet pump assembly to absorb axial loads and keep the impeller shaft properly positioned. It is intended for riders performing routine pump maintenance or rebuilding a worn driveline on their Sea-Doo SPX 800.

Built For Performance

• Direct cross-reference to OEM part number 293350020
• Controls axial play in the jet pump shaft assembly
• Helps reduce vibration and driveline wear
• Constructed for marine use in wet environments
• Simple drop-in replacement during pump service

Fits These Machines

• for Sea-Doo SPX 800 (1997)
• for Sea-Doo SPX 800 (1998)
• for Sea-Doo SPX 800 (1999)

On-The-Job Use

• Jet pump rebuilds and driveline refresh
• Replacing a worn or seized thrust washer
• Seasonal maintenance on personal watercraft
• Restoring proper impeller shaft end play

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: This is a replacement thrust washer cross-referenced to OEM 293350020 and is not an original Sea-Doo product. Confirm your model and serial number before ordering.

Q: How many thrust washers are included? A: This listing covers a single thrust washer unless otherwise stated. Check your service manual for the quantity required for your jet pump assembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.