293350020 Thrust Washer for Sea-Doo XP 650 1993-1995 Jet Ski Part

Thrust Washer for Sea-Doo XP 650

This thrust washer for Sea-Doo XP 650 watercraft is a replacement driveline component that controls end play on the jet pump shaft, cross-referencing OEM 293350020.

Overview

This thrust washer for Sea-Doo XP 650 models is a wear component that sits in the jet pump assembly to absorb axial load and keep the impeller shaft properly positioned. It is built for riders maintaining or rebuilding the pump on a 1993 through 1995 XP 650. Installing a fresh thrust washer for Sea-Doo driveline service helps protect the shaft and bearing surfaces from excess movement.

Built For Performance

• Cross-references OEM part number 293350020
• Washer design controls axial end play on the pump shaft
• Constructed to withstand continuous marine driveline load
• Direct replacement fit in the jet pump assembly
• Sold individually for straightforward service

Fits These Machines

• for Sea-Doo XP 650 1993
• for Sea-Doo XP 650 1994
• for Sea-Doo XP 650 1995

On-The-Job Use

• Jet pump rebuilds and driveline refreshes
• Repairing play in the pump shaft assembly
• Routine maintenance on older Sea-Doo watercraft
• Seasonal prep before riding season

Specs At A Glance

Good To Know

Q: How many thrust washers should I order for one pump? A: Order the same quantity as the original assembly calls for, since some setups use more than one washer to set correct shaft end play. Reusing measured shims and washers in their original positions keeps tolerances accurate.

Q: Can I install this washer without special tools? A: Basic hand tools handle most pump removal and reassembly, though a torque wrench helps when tightening fasteners to spec. If the shaft shows scoring or the bearing feels rough, address that as well.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.