2953XC Ring Set 75.00mm for Wiseco

Ring Set, 75.00mm for Wiseco

This piston ring set is a 75.00mm replacement ring set that seals the combustion chamber and controls oil on Wiseco piston applications, cross-referencing part number 2953XC.

Overview

The 2953XC Ring Set, 75.00mm is a piston ring set built to restore compression and oil control in a 75.00mm bore. Each Ring Set, 75.00mm is intended for rebuilders and riders refreshing a top end who need rings matched to Wiseco piston specifications. This 75.00mm ring set gives a fresh sealing surface so the engine can hold compression and run cleanly again.

Built For Performance

• 75.00mm bore size for a precise fit in the matching cylinder
• Ring set configuration for one piston application
• Cross-references Wiseco part number 2953XC
• Designed to seal combustion pressure and control oil at the ring lands
• Suited to top-end rebuilds and piston replacement jobs

On-The-Job Use

• Top-end rebuilds where a piston is replaced or refreshed
• Cylinder reconditioning jobs that call for a matched ring set
• Compression restoration on tired or smoky engines
• Routine maintenance on engines that consume oil

Specs At A Glance

Good To Know

Q: How do I know this ring set fits my piston? A: It is sized for a 75.00mm bore and cross-references part number 2953XC, so check that your piston and cylinder match that specification. Confirming the part number against your current piston is the safest way to order correctly.

Q: Do rings need to be gapped before installation? A: Piston rings should always be checked for end gap in the cylinder before final assembly, following the piston maker's specifications. Correct gapping protects against ring butting and poor sealing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.