295501143 Carbon Ring for Sea-Doo GTI 130 1503 2008 2011-2015

Carbon Ring for Sea-Doo

The carbon ring for Sea-Doo personal watercraft seals the driveshaft where it passes through the hull, keeping water out of the engine compartment; it cross-references OEM 295501143.

Overview

This carbon ring for Sea-Doo is a driveshaft seal component that keeps water from entering the hull while allowing the shaft to spin freely. It is built for riders maintaining a GTI 130 or 1503-powered machine and is a direct replacement for the worn seal ring on your ski. Riders who service their own pump and shaft assemblies will find this carbon ring for Sea-Doo a straightforward swap during routine maintenance.

Built For Performance

• Carbon sealing face runs cool against the driveshaft for a consistent watertight seal
• Cross-references OEM part number 295501143 for easy verification
• Fits 1503 engine applications in the listed model years
• Withstands constant contact with water and driveline vibration
• Compact, lightweight design keeps rotating mass low

Fits These Machines

• for Sea-Doo GTI 130
• for Sea-Doo 1503 applications
• for Sea-Doo model years 2008 and 2011-2015

On-The-Job Use

• Driveshaft sealing on personal watercraft
• Routine pump and driveline service
• Replacing a worn or leaking carbon seal ring
• Pre-season maintenance on a GTI 130

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: No, it is an aftermarket carbon ring that cross-references OEM 295501143. It is not manufactured by Sea-Doo.

Q: Will it fit my ski? A: It is intended for the GTI 130 and 1503 applications listed above. Confirm your model year and engine before ordering, since fit can vary by serial number.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.