295501143 Carbon Ring for Sea-Doo GTI SE DT 1503 2007

Carbon Ring for Sea-Doo

This carbon ring for Sea-Doo personal watercraft, OEM cross-reference 295501143, seals the driveshaft to the impeller housing to keep water out of the hull.

Overview

This carbon seal ring for Sea-Doo is a replacement driveshaft sealing component that keeps lake or sea water from entering the engine compartment through the through-hull fitting. Built to the 295501143 reference, this carbon ring for Sea-Doo restores the seal surface where the driveshaft passes through the hull. It suits riders and mechanics servicing 1503-powered GTI SE models.

Built For Performance

• Carbon sealing face designed to run against the stainless driveshaft ring
• Direct replacement for OEM reference 295501143
• Withstands continuous contact with water and rotational friction
• Fits 1503 engine driveshaft seal assemblies
• Helps prevent water ingress into the hull cavity
• Compact, lightweight part for straightforward seal service

Fits These Machines

• for Sea-Doo GTI SE DT 1503, 2007

On-The-Job Use

• Driveshaft seal replacement during hull or engine service
• Cooling system and impeller housing maintenance
• Pre-season inspection and refresh of 1503-powered skis
• Correction of water leaks around the driveshaft pass-through

Specs At A Glance

Good To Know

Q: How do I know the carbon ring needs replacing? A: Water accumulating in the hull or a scored mating surface on the driveshaft ring are typical signs. Inspect the carbon face for cracks, grooves, or uneven wear whenever the seal is exposed.

Q: Should the driveshaft ring be replaced at the same time? A: A new carbon ring seals best against a clean, unmarked mating surface. Replacing both together restores the full seal and lowers the chance of a repeat leak.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.