295501143 Carbon Ring for Sea-Doo GTI STD DT 1503 2007

Carbon Ring for Sea-Doo

This carbon ring for Sea-Doo replaces OEM part 295501143, sealing the driveshaft to the hull on 1503-equipped watercraft to block water from the engine compartment.

Overview

This carbon ring for Sea-Doo is a replacement driveshaft seal for 1503-powered craft. It sits at the hull pass-through, holding back water while the shaft rotates under load. Riders maintaining a GTI STD or DT will find it restores the seal that wears from continuous use.

Built For Performance

• Carbon-based seal material built for rotating shaft contact
• Cross-references OEM part number 295501143
• Made for the 1503 engine platform
• Precision-formed to seat against the driveshaft interface
• Handles repeated immersion and sustained shaft rotation

Fits These Machines

• for Sea-Doo GTI STD 1503, 2007
• for Sea-Doo GTI DT 1503, 2007

On-The-Job Use

• Driveline seal replacement on 1503-powered Sea-Doo craft
• Rebuilding the driveshaft sealing surface after wear
• Seasonal maintenance on personal watercraft

Specs At A Glance

Good To Know

Q: How can I tell if this carbon ring is worn out? A: Water accumulating in the hull, a loose seal around the driveshaft, or visible wear on the carbon face all suggest replacement. Check it whenever the driveline is disassembled.

Q: Is this the same seal used on both GTI STD and GTI DT models? A: The 1503 platform shares the same driveshaft seal arrangement, so this carbon ring works for both variants. Confirm against your model and year before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.