295501143 Carbon Ring for Sea-Doo GTS 130 1503 2011-2013

Carbon Ring for Sea-Doo

This carbon ring for Sea-Doo watercraft replaces OEM part 295501143, sealing the driveshaft to the hull to keep water out of the engine compartment.

Overview

This carbon ring for Sea-Doo is a direct replacement seal that fits between the driveshaft and the hull on 1503-powered models. It keeps water where it belongs while the shaft spins, protecting the engine bay and driveline from spray intrusion. Built for riders maintaining a GTS 130 or similar craft, it restores the seal that wears over time.

Built For Performance

• Carbon-based seal material formulated for rotating shaft contact
• Matches OEM part number 295501143 for direct fitment
• Designed for the 1503 engine platform
• Precision-formed to seat against the driveshaft interface
• Withstands continuous immersion and shaft rotation

Fits These Machines

• for Sea-Doo GTS 130 1503, 2011-2013

On-The-Job Use

• Routine driveline seal replacement on 1503-powered Sea-Doo craft
• Rebuilding the driveshaft sealing surface after wear
• Seasonal maintenance on personal watercraft

Specs At A Glance

Good To Know

Q: How do I know if my carbon ring needs replacing? A: Excess water in the hull, a loose driveshaft seal, or visible wear on the carbon face usually point to replacement. Inspect it any time the driveline is apart.

Q: Does this carbon ring require special tools to install? A: Installation follows standard Sea-Doo driveshaft seal service procedures for the 1503 platform. Work with a service manual to confirm torque and seating steps for your model.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.