295501143 Carbon Ring for Sea-Doo GTX LTD SCIC 1503 2005

Carbon Ring for Sea-Doo

This carbon ring, part number 295501143, is a replacement sealing component for the driveshaft on 2005 Sea-Doo GTX LTD SCIC 1503 watercraft, helping keep water out of the hull where the shaft passes through.

Overview

This carbon ring is a direct-fit sealing part for the 2005 Sea-Doo GTX LTD SCIC 1503, referenced under part number 295501143. The ring seats against the driveshaft to form a watertight seal at the hull passage, protecting the engine compartment from water intrusion. It is intended for riders performing routine driveline maintenance or replacing a worn carbon ring.

Built For Performance

• Carbon face material designed for low-friction contact against the driveshaft
• Seals the driveshaft passage to keep water out of the engine compartment
• Direct replacement for part number 295501143
• Resists wear from continuous shaft rotation under load
• Simple install during routine driveline service

Fits These Machines

• for Sea-Doo GTX LTD SCIC 1503, 2005

On-The-Job Use

• Routine driveshaft seal replacement on the 2005 GTX LTD SCIC 1503
• Maintenance after hull or driveline service
• Repair when water intrusion is traced to the shaft seal area

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: This is an aftermarket carbon ring made for Sea-Doo watercraft, not an original factory part. It is referenced to part number 295501143 for compatibility.

Q: Can I install this carbon ring myself? A: Many riders replace the carbon ring during routine driveline service with basic tools. If you are unsure about driveshaft removal, have a qualified technician handle the install.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.