295501143 Carbon Ring for Sea-Doo GTX S/C 1503 2003-2006

Carbon Ring for Sea-Doo

The carbon ring for Sea-Doo provides the rotating seal between the driveshaft and the hull, helping block water from entering the engine bay while the shaft turns; it is a replacement component referenced by OEM part number 295501143.

Overview

This carbon ring for Sea-Doo is a sealing wear part used on the driveshaft pass-through, pressing against a stainless steel ring to keep the bilge dry. It is intended for owners and shops servicing the GTX S/C 1503 platform during routine driveline maintenance. Swapping a worn carbon ring for Sea-Doo helps stop water intrusion and restores a reliable seal.

Built For Performance

• Carbon sealing face that runs against a stainless steel mating ring
• Replacement part referenced by OEM number 295501143
• Engineered to handle constant contact with a spinning driveshaft
• Resists abrasion from grit suspended in cooling water
• Seals the hull pass-through to help keep the engine compartment dry

Fits These Machines

• for Sea-Doo GTX S/C 1503, model years 2003-2006

On-The-Job Use

• Driveline seal service during routine PWC maintenance
• Replacing a leaking carbon seal on a 1503-equipped GTX S/C
• Pre-season service before launching a ski
• Shop repairs of driveshaft sealing assemblies

Specs At A Glance

Good To Know

Q: What else should be checked during replacement? A: Inspect the stainless steel mating ring for grooves or scoring and replace it alongside the carbon ring if wear is present.

Q: Is this an original Sea-Doo part? A: This is an aftermarket replacement component referenced by OEM number 295501143; verify your model and serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.