295501143 Carbon Ring for Sea-Doo GTX STD 1503 2004-2006

Carbon Ring for Sea-Doo

The carbon ring for Sea-Doo serves as the sealing component between the driveshaft and the hull, helping keep water out of the engine compartment while allowing the shaft to spin freely; it is a direct replacement referenced by OEM part number 295501143.

Overview

This carbon ring for Sea-Doo is a wear component in the driveline sealing system, sitting against the stainless steel ring to form a watertight barrier where the driveshaft passes through the hull. It is built for personal watercraft owners performing routine maintenance or rebuilding a worn seal assembly on the GTX STD 1503 platform. Replacing a pitted or grooved carbon ring for Sea-Doo helps restore proper sealing and keeps the bilge dry.

Built For Performance

• Carbon sealing face designed to run against a stainless steel mating ring
• Direct replacement referenced by OEM part number 295501143
• Withstands continuous contact with a rotating driveshaft
• Resists wear from grit and debris carried in cooling water
• Maintains a watertight seal at the hull pass-through

Fits These Machines

• for Sea-Doo GTX STD 1503, model years 2004-2006

On-The-Job Use

• Driveline seal replacement during routine PWC maintenance
• Rebuilding a leaking hull pass-through on a 1503-equipped GTX
• Seasonal service before returning a ski to the water
• Shop repairs on driveshaft sealing assemblies

Specs At A Glance

Good To Know

Q: Should the stainless steel ring be replaced at the same time? A: It is good practice to inspect the mating stainless ring for grooves or scoring and replace it together with the carbon ring when wear is found.

Q: Is this an original Sea-Doo part? A: This is an aftermarket replacement part referenced by OEM number 295501143; confirm your model and serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.