295501205 Support Ring for Sea-Doo RXT STD 260 1503 2017

Support Ring for Sea-Doo

The support ring for Sea-Doo personal watercraft secures and centers the driveshaft assembly, and it matches OEM reference 295501205.

Overview

This support ring for Sea-Doo is a direct-fit driveline component made to hold the shaft steady inside the hull and keep vibration low at speed. It suits riders and mechanics replacing a worn or corroded ring on the 1503 engine platform. The support ring for Sea-Doo installs with standard tools and follows the original mounting points.

Built For Performance

• Precision formed to OEM reference 295501205
• Corrosion resistant finish suited to wet marine environments
• Maintains driveshaft alignment under load
• Reduces driveline vibration at high RPM
• Drop-in replacement using factory mounting points

Fits These Machines

• for Sea-Doo RXT STD 260 1503, 2017
• for Sea-Doo RXT 260 1503 models using the same hull and engine layout

On-The-Job Use

• Routine driveshaft and jet pump service
• Rebuilding a 1503 engine driveline
• Replacing a pitted or damaged support ring
• Pre-season inspection before the first launch

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: No. It is an aftermarket support ring built to OEM reference 295501205 and is not manufactured by Sea-Doo. It mounts at the factory location for the 1503 platform.

Q: Can I reuse the old mounting hardware? A: Inspect the fasteners and replace any that are stretched, pitted, or seized. New hardware is recommended during driveline service.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.