295501205 Support Ring for Sea-Doo Wake Pro 230 1503 2017-2019

Support Ring for Sea-Doo Wake Pro 230 1503

This support ring is a driveline mounting component that secures the jet pump and shaft assembly on 2017-2019 Sea-Doo Wake Pro 230 models, carrying OEM cross-reference 295501205.

Overview

This support ring is built to hold the jet pump and driveshaft steady on Sea-Doo Wake Pro 230 1503 watercraft from 2017 through 2019. The support ring maintains correct alignment between the engine output and the impeller housing so power transfers cleanly through the driveline. It suits riders replacing a worn or corroded ring during routine pump maintenance or a full rebuild.

Built For Performance

• Direct-fit replacement for OEM part number 295501205
• Rigid construction that resists flex under pump load
• Machined to hold shaft alignment within original tolerances
• Corrosion-resistant finish suited to repeated water exposure
• Bolt-on installation using factory mounting points

Fits These Machines

• for Sea-Doo Wake Pro 230 1503 (2017-2019)

On-The-Job Use

• Jet pump removal and rebuild service
• Driveshaft alignment checks and repairs
• Seasonal maintenance on personal watercraft
• Restoring a PWC that has sat out of the water

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: This is an aftermarket support ring manufactured to fit the Sea-Doo Wake Pro 230 1503, not an original factory item. It cross-references OEM part number 295501205.

Q: Should the support ring be replaced with other pump components? A: Rings are commonly replaced alongside wear rings, bearings, and seals when the pump is apart for service. Inspect the surrounding driveline parts while access is open.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.