2992LT Ring Set 76.00mm for Wiseco

Ring Set, 76.00mm for Wiseco

This 76.00mm ring set for Wiseco restores proper sealing and compression on compatible high-performance pistons during a top-end rebuild.

Overview

The 76.00mm ring set for Wiseco is a piston ring kit sized to a 76.00mm bore for use with the matching Wiseco piston assembly. It seals combustion gases, manages oil control and helps maintain compression on rebuilt engines. This ring set for Wiseco is intended for riders and engine builders servicing a 76.00mm piston application.

Built For Performance

• 76.00mm bore sizing matched to the corresponding Wiseco piston.
• Supplied as a matched ring set for the listed piston.
• Built to Wiseco ring specifications for the application.
• Contributes to compression sealing and oil control.

On-The-Job Use

• Top-end rebuilds on compatible 76.00mm piston engines.
• Ring replacement when servicing a Wiseco piston.
• Engine assembly requiring fresh rings for proper sealing.

Specs At A Glance

Good To Know

Q: How do I confirm this ring set matches my piston? A: It is a 2992LT ring set sized for a 76.00mm bore, so check the part number and bore size against your piston before ordering. Refer to your piston spec or service manual.

Q: Are new rings needed with a new piston? A: New rings are typically fitted during a top-end rebuild to help restore sealing and compression. Follow the recommended ring end gap and installation specs for your engine.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.