2PCS 2" Wide 4°Degree Steel Leaf Spring Degree Shims Silver~~

Steel Leaf Spring Degree Shims

These steel leaf spring degree shims adjust the rear pinion angle of leaf-sprung vehicles to correct driveline vibrations.

Overview

These steel leaf spring degree shims adjust axle alignment to eliminate vibrations caused by suspension lifts or drops. They correct the drive shaft angle by tilting the axle housing relative to the leaf spring pack. Off-road builders and suspension mechanics use these steel leaf spring degree shims to restore proper geometry after altering ride height.

Built For Performance

• Solid steel construction resists compression under heavy axle loads
• Four-degree taper corrects moderate pinion angle issues
• Two-inch width matches standard light truck leaf springs
• Corrosion-resistant silver finish prevents rust and decay

On-The-Job Use

• Correcting drive shaft vibration after installing a suspension lift kit
• Aligning the rear differential pinion angle for highway driving
• Fine-tuning custom suspension setups on classic utility trucks

Specs At A Glance

Good To Know

Q: Are longer center pins required to install these shims? A: Yes, since these shims add thickness, the spring center pin must be long enough to pass through the shim.

Q: Which way should the thick end of the shim face? A: The direction depends on whether the pinion needs to be raised or lowered; consult drive shaft angle measurements to decide.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.