2Pcs Front Complete Strut & Coil Spring Assembly For Nissan Altima 2019-2022 FWD

2Pcs Front Complete Strut & Coil Spring Assembly For Nissan Altima 2019-2022 FWD

This pair of front complete strut and coil spring assemblies replaces the worn front suspension units on FWD Nissan Altima models from 2019 through 2022, restoring ride height and damping.

Overview

This two-piece front complete strut and coil spring assembly set is a ready-to-install replacement for the front suspension on FWD Nissan Altima models from 2019 to 2022. Each unit ships fully assembled with the strut, coil spring, and mount so the old corner comes off and the new one bolts straight in. A practical fix for worn dampers, sagging springs, or noisy front suspension on a daily-driven Altima.

Built For Performance

• Complete assembly includes strut, coil spring, and upper mount
• Pre-assembled for direct bolt-on installation without a spring compressor
• Gas-charged damper for consistent rebound control
• Coil spring rated for the front axle load of the Altima
• Sold as a pair to service both front corners at once

Fits These Machines

• for Nissan Altima 2019 FWD
• for Nissan Altima 2020 FWD
• for Nissan Altima 2021 FWD
• for Nissan Altima 2022 FWD

On-The-Job Use

• Replacing worn front struts on a high-mileage daily driver
• Correcting a sagging or bouncy front end
• Servicing both front corners in a single job
• Restoring factory ride height after spring fatigue

Specs At A Glance

Good To Know

Q: Does this fit AWD Altima models? A: No, this set is listed for FWD models only. Check your drivetrain before ordering.

Q: Is an alignment needed after installation? A: Yes, a professional alignment is recommended after replacing front strut assemblies to protect tire wear.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.