2Pcs Front Lower Control Arms w/ Ball Joint for Mercedes S550e W222 3.0L 15-17

Front Lower Control Arms with Ball Joint for Mercedes S550e W222

This pair of front lower control arms with ball joints replaces the worn front lower suspension links on Mercedes S550e W222 3.0L models from 2015 to 2017, restoring proper geometry and steering response.

Overview

This set of two front lower control arms with ball joints is a suspension replacement for the Mercedes S550e W222 chassis. Each arm locates the lower suspension point and the pre-installed ball joint allows the knuckle to pivot through steering and suspension travel. A solid choice for drivers chasing clunks, vague steering, or uneven tire wear caused by worn bushings and joints.

Built For Performance

• Two front lower control arms supplied as a matched pair
• Ball joints pre-installed for a simpler installation
• Forged or cast arm construction built to carry suspension loads
• Rubber bushings pressed in to isolate road vibration
• Direct replacement for the original front lower arms

Fits These Machines

• for Mercedes S550e W222 3.0L 2015-2017

On-The-Job Use

• Replacing worn front lower arms on W222 S550e sedans
• Correcting steering play and front end clunks
• Restoring alignment geometry after suspension wear

Specs At A Glance

Good To Know

Q: Should both control arms be replaced together? A: Replacing both sides at once keeps wear even and avoids a repeat alignment, which is common practice for front lower arms.

Q: Is an alignment required after installation? A: Yes, a professional wheel alignment should follow any control arm replacement to bring camber and toe back into specification.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.