2Pcs Front Shock Strut Spring Assembly For Toyota 4Runner Limited 4WD 2010-2024

Front Shock Strut Spring Assembly for Toyota 4Runner

This two-piece front shock strut spring assembly set replaces the tired front units on your 4Runner, bringing back controlled damping and correct ride height.

Overview

These front shock strut spring assemblies for Toyota 4Runner ship as a two-piece set covering both front corners. Each front shock strut spring assembly comes fully assembled with damper, coil spring, and mount for a direct bolt-in swap. Built for the Limited 4WD 4.0L model from 2010 through 2024.

Built For Performance

• Pre-assembled strut, spring, and upper mount
• Gas-charged design matched for the 4.0L 4WD platform
• Coil spring rated to factory ride height and load
• Protective coating against road salt and moisture
• Two-piece set covering both front sides
• Stock mounting points for a direct fit

Fits These Machines

• for Toyota 4Runner Limited 4WD 2010-2024

On-The-Job Use

• Everyday commuting and highway driving
• Light off-road and gravel travel
• Lifting the front end back to stock height
• Replacing worn front struts on higher-mileage trucks

Specs At A Glance

Good To Know

Q: What is included in this two-piece set? A: You receive one left and one right front complete strut and spring assembly. Each unit is pre-built with the spring and mount already attached.

Q: Is a spring compressor needed for installation? A: No, the spring is already seated on the strut, so the assembly installs as one piece. Have the alignment checked once both sides are fitted.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.